A practical reference on Stenabolic: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2025-08-02. Anything still debated is marked as such rather than presented as settled.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
Detection of SR9009 in biological samples usually relies on liquid chromatography coupled to tandem mass spectrometry. This approach separates the compound from matrix components and identifies it by mass transitions. Because SR9009 can undergo metabolism, laboratories often look for both parent drug and specific metabolites. Sample preparation may involve protein precipitation or solid-phase extraction. Method validation examines sensitivity, carryover, and interference from related substances, and reference standards are required for accurate calibration.
Storage recommendations for SR9009 reference material typically specify a freezer at -20 °C or lower, with protection from moisture and light. Repeated freeze-thaw cycles can degrade small molecules and introduce variability. Stock solutions in dimethyl sulfoxide are often aliquoted to avoid repeated handling. Stability studies may examine degradation under heat, humidity, and light exposure. The compound's thiophene and nitro groups can participate in reactions that alter analytical signals over time, so such changes affect quantitative results.
Quality control for research materials includes identity confirmation by nuclear magnetic resonance and purity assessment by high-performance liquid chromatography. Mass spectrometry provides molecular weight confirmation and can detect related impurities. Purchasers should request a certificate of analysis that lists lot-specific data. Online products advertised for human use often lack such documentation. Distinguishing legitimate research material from mislabeled or contaminated samples is a recurring challenge in independent testing, and independent laboratories may use orthogonal methods to verify identity.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water; stock solutions use organic solvent. |
| Storage | -20°C, desiccated, protected from light | Limits hydrolysis and photodegradation. |
| Analytical method | HPLC-UV/MS | Used for identity and purity assessment. |
| Synonyms | SR9009, Stenabolic | Naming varies by supplier. |
Analytical chemists detect SR9009 with liquid chromatography-tandem mass spectrometry, commonly abbreviated LC-MS/MS. Sample preparation may involve protein precipitation, liquid-liquid extraction, or solid-phase extraction before analysis. Laboratories can target the parent compound or its metabolites, depending on the matrix and the purpose of testing. Anti-doping methods require sensitive and specific assays because concentrations in biological samples can be low. Reference standards and validated methods are essential for reliable identification and quantification.
Regulatory agencies have not approved SR9009 for human therapeutic use. It is typically sold as a research chemical with labels stating that it is not for human consumption. The World Anti-Doping Agency prohibits the substance in sport, generally under the category of non-approved substances. Customs and national laws may restrict importation, sale, or possession. Product quality and legal status can vary by country and vendor, and therapeutic claims are not permitted in regulated advertising because the compound lacks approval.
Regulatory treatment of SR9009 reflects its investigational status. The compound has no approved human therapeutic indication, and sports authorities prohibit its use. It appears on anti-doping lists as a non-approved substance or metabolic modulator, depending on the list version. Products sold online as research chemicals are not quality-controlled medicines, so their identity and purity can differ from the label. Such products may also contain unlisted compounds, which complicates both testing and safety assessment.
Scientific discussion of SR9009 often separates animal evidence from human anecdote. Rodent studies provide controlled data on endurance, metabolism, and gene expression, but they use specific strains, doses, and treatment durations. Human reports are mostly uncontrolled and cannot establish cause and effect. Open questions include oral bioavailability, tissue distribution, metabolic stability, and long-term effects. Review articles generally call for more rigorous pharmacokinetic and safety research before any clinical use could be considered.
Laboratory samples of SR9009 are typically supplied as a white to off-white powder. The compound dissolves readily in organic solvents such as dimethyl sulfoxide and ethanol, while its solubility in water is low. Because of this solubility profile, researchers often prepare concentrated stock solutions in an organic solvent before diluting them into aqueous assay buffers. Light exposure, moisture, and repeated freeze-thaw cycles can degrade many small molecules, so handling procedures usually aim to minimize these factors. Purity is commonly checked before use.
Storage conditions for research-grade SR9009 generally involve a freezer at approximately minus twenty degrees Celsius, sometimes lower for long-term preservation. Containers should remain tightly closed and protected from light. Desiccants may be used to limit moisture uptake. Solutions are often stored in aliquots to avoid repeated warming and cooling. Stability data for the compound under various conditions are limited, so laboratories typically follow supplier recommendations and verify performance through periodic analytical checks rather than assuming indefinite stability.
Identity and purity testing for SR9009 commonly uses liquid chromatography coupled with tandem mass spectrometry. This method separates the compound from matrix components and detects it by mass-to-charge transitions, providing sensitive and specific confirmation. Nuclear magnetic resonance spectroscopy can support structural identification, while high-performance liquid chromatography with ultraviolet detection may estimate purity. Because online products labeled as SR9009 may contain other substances or no active compound at all, independent verification is important in research settings. Certificates of analysis are useful but not a substitute for in-house testing.
SR9009 binds REV-ERB receptors and alters their repressive activity on target genes. This action can change transcription of genes involved in lipid handling, glucose metabolism, and mitochondrial function. In rodent studies, treated animals have shown changes in muscle oxidative capacity and exercise performance, though effects vary by dose, duration, and model. The precise molecular steps connecting receptor binding to whole-body outcomes are still an active area of investigation. Findings in animals do not automatically translate to humans.
Because REV-ERB receptors are core clock components, SR9009 has been examined for effects on daily rhythms as well as metabolism. Research has explored whether the compound can shift or reinforce circadian gene expression in tissues such as liver and muscle. Some studies report improved metabolic markers in obese or diabetic mice, while others show context-dependent responses. Questions remain about which effects are direct, which are secondary to timing, and how they might differ across species.
SR9009 is a synthetic small molecule studied as an agonist of REV-ERB nuclear receptors. REV-ERB alpha and REV-ERB beta help regulate circadian rhythms and metabolic gene expression. In laboratory research, SR9009 has been used to probe how these receptors affect skeletal muscle, liver, and adipose tissue. The compound was identified in academic drug-discovery work and is often described in scientific literature by its chemical name and research code. It is not an approved medicine, and human clinical data remain limited or absent.
=== Prescription drug monitoring === In 2016, the CDC published its "Guideline for Prescribing Opioids for Chronic Pain", recommending opioids only be used when benefits for pain and function are expected to outweigh risks, and then used at the lowest effective dosage, with avoidance of concurrent opioid and benzodiazepine use whenever possible. Silvia Martins, an epidemiologist at Columbia University, has suggested getting out more information about the risks:The greater "social acceptance" for using these medications (versus illegal substances) and the misconception that they are "safe" may be contributing factors to their misuse. Hence, a major target for intervention is the general public, including parents and youth, who must be better informed about the negative consequences of sharing with others medications prescribed for their own ailments. Equally important is the improved training of medical practitioners and their staff to better recognize patients at potential risk of developing nonmedical use, and to consider potential alternative treatments as well as closely monitor the medications they dispense to these patients. As of April 2017, prescription drug monitoring programs (PDMPs) exist in every state. A person on opioids for more than three months has a 15-fold (1,500%) greater chance of becoming addicted. The CDC's "Guideline for Prescribing Opioids for Chronic Pain" offers many non-pharmacological options as alternatives to prescribing opioids. Physical therapist interventions is an example that is offered in regards to an alternative to prescribing opioids.
Melanoma inhibitory activity protein 3 (MIA3), also known as transport and Golgi organization protein 1 (TANGO1), is a protein that in humans is encoded by the MIA3 gene on chromosome 1. It is ubiquitously expressed in many tissues and cell types. MIA3 localizes to the endoplasmic reticulum (ER) exit site, where it binds bulky cargo molecules such as collagens and creates mega transport carriers for the export of cargoes from the ER. This function suggests that it plays a role in assembly of extracellular matrix (ECM) and bone formation. MIA3 has been demonstrated to contribute to both tumor suppression and progression. The MIA3 gene also contains one of 27 loci associated with increased risk of coronary artery disease.. A TANGO1 like protein called TALI is expressed in liver and intestine and shown to be required for the export of bulky very Low density lipoproteins (VLDL) and chylomicrons. TANGO1 and TALI assemble into rings around COPII coats and this function is necessary for export of bulky cargoes. The discovery of TANGO1 and understanding its function has revealed that cargo export from the ER is not be vesicles but involves transient tunnels between the ER exit site and the next compartment of the secretory pathway. Biallelic Mutations in TANGO1 cause syndrome disease and complete loss of TANGO1 leads of defects in bone mineralization.
Examination of remains of Homo erectus from Kenya, which are about 1.6 million years old, has revealed signs typical of yaws. The genetic analysis of the yaws causative bacteria—Treponema pallidum pertenue—has led to the conclusion that yaws is the most ancient of the four known Treponema diseases. All other Treponema pallidum subspecies probably evolved from Treponema pallidum pertenue. Yaws is believed to have originated in tropical areas of Africa and spread to other tropical areas of the world via immigration and the slave trade. The latter is likely the way it was introduced to Europe from Africa in the 15th century. The first unambiguous description of yaws was made by the Dutch physician Willem Piso. Yaws was clearly described in 1679 among African slaves by Thomas Sydenham in his epistle on venereal diseases, although he thought that it was the same disease as syphilis. The causative agent of yaws was discovered in 1905 by Aldo Castellani in ulcers of patients from Ceylon. The current English name is believed to be of Carib origin, from "yaya", meaning sore. Towards the end of the Second World War, yaws became widespread in the North of Malaya under Japanese occupation. After the country was liberated, the population was treated for yaws by injections of salvarsan, of which there was a great shortage, so only those with stage 1 were treated.
Sources: en.wikipedia.org
==== Mass spectrometry–based methods ==== In mass spectroscopy-based proteomics there are three major steps needed for peptide identification: sample preparation, separation of peptides, and identification of peptides. Several groups have focused on oocytes or very early cleavage-stage cells since these cells are unusually large and provide enough material for analysis. Another approach, single cell proteomics by mass spectrometry (SCoPE-MS) has quantified thousands of proteins in mammalian cells with typical cell sizes (diameter of 10-15 μm) by combining carrier-cells and single-cell barcoding. The second generation, SCoPE2, increased the throughput by automated and miniaturized sample preparation; It also improved quantitative reliability and proteome coverage by data-driven optimization of LC-MS/MS and peptide identification. The sensitivity and consistency of these methods have been further improved by prioritization, and massively parallel sample preparation in nanoliter size droplets. Another direction for single-cell protein analysis is based on a scalable framework of multiplexed data-independent acquisition (plexDIA) enables time saving by parallel analysis of both peptide ions and protein samples, thereby realizing multiplicative gains in throughput. The separation of differently sized proteins can be accomplished by using capillary electrophoresis (CE) or liquid chromatography (LC) (using liquid chromatography with mass spectroscopy is also known as LC-MS). This step gives order to the peptides before quantification using tandem mass-spectroscopy (MS/MS).
Butter heater: In the early 1950s, the butter conditioner's patent was filed and published by the inventor Nave Alfred E. This feature was supposed to "provide a new and improved food storage receptacle for storing butter or the like which may quickly and easily be removed from the refrigerator cabinet for the purpose of cleaning." Because of the high interest to the invention, companies in UK, New Zealand, and Australia started to include the feature into the mass refrigerator production and soon it became a symbol of the local culture. However, not long after that it was removed from production as according to the companies this was the only way for them to meet new ecology regulations and they found it inefficient to have a heat generating device inside a refrigerator. Later advances included automatic ice units and self compartmentalized freezing units.
Denbu (田麩), a food made by boiling powdered dried bonito flakes in sake and soy sauce, appears in an ancient 17th-century document called "Kokin Ryouri-shu" ("Collection of Ancient and Modern Cookbooks"). Tsukudani (佃煮), which appears in the 19th century colloquial dictionary "Risogonshuran" (俚言集覧) compiled by Ota Zensai (太田全斎), is made by boiling down small fish, shellfish, seaweed, and other ingredients in soy sauce to a rich flavor. The use of tsukudani is similar to furikake, but it is not usually called furikake in Japan today. The modern furikake was invented by several companies between the 1900s and 1920s for the purpose of tasty nourishment. Regarding modern furikake, the Japan Furikake Association recognized Futaba's "Gohan no Tomo" as the original in 1994, but revoked this recognition in 2022 and is conducting a reexamination. The association's conclusion has not been reached as of 2023. One account of the origin of furikake is that it was developed during the Taishō period (1912–1926) by a pharmacist in Kumamoto prefecture named Suekichi Yoshimaru (吉丸末吉). To address calcium deficiency in the Japanese population, Yoshimaru developed a mixture of ground fish bones with roast sesame seeds, poppy seeds, and seaweed that was made into a powder. This product, which he called Gohan no Tomo (ご飯の友, 'A Friend for Rice'), is generally considered the precursor to contemporary furikake. A food company in Kumamoto later acquired the product and was able to sell it commercially.
Sources: en.wikipedia.org
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.
The solid is generally kept cold, dry, and protected from light. Solutions are often frozen in single-use aliquots to reduce repeated freeze-thaw cycles.
It indicates a material sold for laboratory study, not for human use. The label does not guarantee pharmaceutical purity, sterility, or regulatory approval.
Liquid chromatography-tandem mass spectrometry is a common approach. It can detect the parent compound and its metabolites in biological matrices.